The camera is designed to replicate the size and shape of the existing high level brake light but with the addition of a precision angled camera. Once correctly installed, the camera will automatically power on as soon as the vehicle is put into reverse delivering a PAL video signal via the included 10 metre RCA video cable signal to any monitor with an RCA reverse camera input -The camera is also compatible with any aftermarket car head unit with a suitable video input. If your aftermarket head unit has a dedicated camera input then the camera can be set up so that the rear-view image can be automatically displayed as soon as the car is put into reverse. The camera is not designed for use with original factory-fitted monitors or OEM displays, as vehicle manufacturers do not design their equipment with the required RCA video inputs used by aftermarket cameras. Uses with this item no more wonder what's going on in the back -Displays a reversed camera image on the monitor to duplicate the normal view seen in a rear view mirror.Perfect solution to get rid if that poor rear view visibility on your car, boat, trailer, camper, truck, or any vehicle that has no rear-view mirror or poor rear vision. Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution. Mounted inside will fit into most vehicle key holes, no other installation needed. Small compact size Waterproof Low power consumption High sensitivity Low maintenance Easy and comprehensive installation Night vision Camera. Camera dimensions: (31cm between screw holes, 3.2cm wide) Van hole: (29cm long x 1.5cm wide) TV System:PAL Sensor:CMOS Effective Pixels:682504/728576 Horizontal Sync Frequency:15625KHz Vertical Sync Fre:50Hz Scanning System:2:1 Interlace Sync System: Internal White Balance:Auto Resolution: 420 -480TV lines Signal to noise ratio:> 48dB (AOC on) Current Consumpition:no more 150mA Minimum illumination: 0.5Lux Operating voltage: 12V DC Output line: power supply, signal line, ground Operating temperature: -20? RH95% MAX Storage temperature: -30? Rh95% MAX Lens Angle Deg.
The monitor comes with dual video input i. V1 and V2, with V1 video as the default when the reverse gear is not engaged, once the reverse gear is engaged the monitor automatically switches to V2 video input. Switching between V1 and V2 inputs (when not reversing) can be done by pressing the V1/V2 button on the right side of display or using remote control key:'video select' -The display automatically powers on when reverse gear is engaged, and if there is no video signal, the monitor can be turned on/off by pressing the power button. Screen size: 7 inches Size:25x10.8cm Aspect ratio:16:9 Resolution: 800x480 Contrast ratio: 350:1 Bluetooth: 2.0 Video input: Two video inputs, Automatically display when reversing.Input signal: AV Input standard: PAL / NTSC Current source: DC12V Power: 6W Operating temperature: -20-70 degrees Celsius. Rear view image screen can be up / down / left / right image flip Optional: Bluetooth, digital HD screen, with audio. Instruction Not Included, Professional Installation Is Highly Recommended. Please allow 1-3MM differs due to manual measurement. Due to the different display and different light, the picture may not reflect the actual color of the item. This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Advanced Driver Assistance Systems\Parking Assistance\Camera, Monitor & Sensor Kits". The seller is "rfghfs" and is located in this country: GB. This item can be shipped to United Kingdom.